Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Common System Procedures
Page 3-7About Diskette Drives and Diskettes
3
4. Press
y
The system displays a screen stating that the tape has been formatted.
5. Remove the tape from the tape drive.
6. Press .
About Diskette Drives and Diskettes
Diskette can provide for the storage of information used by the Lucent INTUITY
system. If information must be transferred from a Lucent I
NTUITY system without a
LAN card, diskettes must be used.
Types of Diskettes
The Lucent INTUITY system is not shipped with disks. If you need disks, obtain
unformatted 3.5-inch disks. The disks can be either:
■ High density (1.44-Mbyte)
■ Low density (720-Kbyte)
Inserting and Removing Diskettes
Inserting the Diskettes
To insert a diskette, do the following:
1. Locate the diskette drive on the front of the MAP/5P (Figure 3-3
).
2. Check the read/write switch to make sure that the diskette is not
write-protected.
3. Insert the diskette in the drive.
NOTE:
The light on the diskette drive is on when the drive is in use. If the
light is not on, the diskette drive is idle.
ENTER