Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Common System Procedures
Page 3-6About Cartridge Drives and Tapes
3
Removing the Cartridge Tape
To remove a cartridge tape, do the following:
!
CAUTION:
You can only remove the tape when the drive is idle, that is, when the light is
not blinking.
1. Press the button on the upper right corner of the drive to reveal part of the
tape.
2. Pull out the tape.
Formatting Cartridge Tapes
Formatting prepares a cartridge tape to receive data. To format a cartridge tape,
do the following:
1. Starting at the Lucent I
NTUITY Main menu (Figure 3-1), select
The system displays the Format UNIX Floppy/Tape menu (Figure 3-5
).
Figure 3-5. Format UNIX Floppy/Tape Menu
2. Select Format Cartridge Tape.
3. Verify that the tape is not write-protected and insert the tape into the tape
drive. See “About Cartridge Drives and Tapes
” above for more
information.
>Format UNIX Floppy/Tape
> UNIX Management
> System Management
> Customer/Services Administration