Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Common System Procedures
Page 3-5About Cartridge Drives and Tapes
3
Inserting the Cartridge Tape
To insert a cartridge tape, do the following:
1. Locate the tape drive on the front of the MAP/5P (Figure 3-3
).
2. Check the read/write dial to make sure that the tape is not write-protected.
The small dial on the front of the tape should be in the horizontal position.
3. Complete Steps a through c to insert the tape in the drive.
a. Press the button on the upper right corner of the drive to open the
drive door.
b. Insert the tape (Figure 3-4
).
c. Close the door to push in the tape.
Figure 3-4. Tape Insertion with a Tape Drive
NOTE:
The light on the tape drive will blink when the drive is in use. If the light is lit
and not blinking, the tape drive is idle.