User Manual

16
 During use, the user must wear goggles, ear protectors and protective
gloves.
 During use, hold the machine with both hands and maintain a safe
standing position. Always consider the reaction moment of the
tool.
 Always work with concentration. Always work in a carefully
considered way and do not use the tool if you are lacking
consideration.
For further safety instructions, please refer to the enclosure.
Before starting the machine, please check the correspondence between
voltage and frequency against the data mentioned on the identification
plate. Voltage differences of + 6 % and – 10 % are allowed.
The Hand-Held Drilling Machine is made in protection class II. Only use
extension cables with a sufficient cross section. A cross section which is too
small could cause a considerable drop in performance and an overheating
of machine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
Cross section in sq. mm
1.5
2.5
110V
20 m
40 m
230V
50 m
80 m
Additional Handle
When using the machine handheld than only with its additional
handle.
For mounting, screw it in the thread on the gearbox housing and fix it tightly.
Tool Protection
Wrong handling can cause damages on the tool and injuries of the user.
Therefore, the following instructions should be observed:
Do not allow blocking of the tool.
Only use original accessories made by EIBENSTOCK.
Electrical Connection