User Manual

4
17. Speaker input (passive speaker)
Put the plug of the supplied speaker cable into this slot and put
the other plug of the speaker cable into the active speaker.
18. LED switch (passive speaker)
Turn the LED ring (frontside) of the passive speaker
on or off.
CONNECT BT-DEVICE
1. Set the search function on of the BT device you want to play the music. See the operating
instructions for that device..
2. Press the “MODE” button until “AUX” will show in display and activate BT-function.
3. Find on your BT-device “VONYX” and make the connection.
If password is required, you can enter "0000".
REMOTE CONTROL
1. Stand-by button
Use this button to put the unit into or out of standby mode.
2. Mode button
Press to switch between BT/USB/SD modes.
3. Previous & next buttons
Press to change to previous or next track.
4. Master volume control
Adjust the overall output level of the sound system.
5. Num pad
Numeric keyboard for selecting presets.
6. Play/pause
Press this button to start or pause play.
7. Equalizer
Press to use EQ function.
8. Enter button
Press to confirm.
9. Mute
Press to mute the device.
10. Stop
Press to stop.
NOTE: Improper use of the batteries may cause battery leakage and corrosion. To operate the remote control correctly, follow
the instructions below:
• Do not insert batteries into the remote control in the wrong direction.
• Do not charge, heat, open or short-circuit batteries. Do not throw batteries into a fire.
• Do not leave dead or exhausted batteries in the remote control.
• Do not use different types of batteries together or mix old and new batteries.
• If you do not use the remote control for a long period of time, remove the batteries to avoid possible damage from
battery corrosion.
• If the remote control does not function correctly or the operating range becomes reduced, replace all batteries with new
ones.
• If battery leakage occurs, wipe the battery liquid from the battery compartment, then insert new batteries.
The batteries can be used for one year in normal condition.