Use and Care Guide

56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER14
UNFOLDING THE SHAFT (ONLY
FOR ST1500SF/ST1500SF-FC)
WARNING:
In order to avoid
pinching your hands or ngers, do not
hold the shaft at the joints.
WARNING:
Do not attempt to
start the trimmer until the shaft has been
locked.
New Hinge
1. Remove the battery pack from the
trimmer.
2. Put your trimmer on the ground or
the oor and make sure that the
cable is inside the shaft, so that it
will not be pinched when closing
the joints. Carefully unfold the shaft
until the two holes in the joint are
accurately aligned (Fig. 2a).
3. Insert the bolt (supplied) and tighten
it with the supplied hex wrench to
lock the shaft in place (Fig. 2b).
Old Hinge
1. Remove the battery pack from the
trimmer.
2. Put your trimmer on the ground and
carefully unfold the shaft. Make sure
that the cable is inside the shaft
so that it will not be pinched when
closing the joints (Fig. 3a).
3. Use the supplied hex wrench to lock
the shaft with the bolts supplied
(Fig. 3b).
3a
3b
2a
2b