Use and Care Manual

56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2100 21
The throwing distance of the snow
blower is adjusted by moving the chute
deector up or down (Fig. 19). Release
the bail switch before adjusting the chute
deector.
1. Squeeze the trigger on the chute
deector handle and move the chute
deector up or down (Fig. 19).
2. Move the chute deector up to
increase the distance that the snow will be thrown.
WARNING:
Do not force the chute so far forward that a gap appears between
the deector and the chute itself. Snow or other debris could be thrown through the
gap and back at the operator, resulting in serious personal injury.
WARNING:
Do not adjust the chute deector while the bail switch is engaged.
Always release the bail switch before adjusting the chute deector.
3. Move the chute deector down to decrease the distance the snow will be thrown.
4. Release the trigger to lock the chute deector in place.
CLEARING A CLOGGING CHUTE
WARNING:
Hands coming in contact with the rotating auger inside the chute is
the most common cause of injury associated with snow blowers. Never use your hand
to clean out the chute.
To Clear the Chute:
1. Shut the motor and auger off!
2. Remove the battery pack(s) from the snow blower.
3. Wait 10 seconds to be sure the auger has stopped rotating.
4. Always use a clean-out tool, such as a wood rod or other clearing tools that are
commercially available; do not use your hand.
19
Triggle
Chute
Deector