Use and Care Guide

56-VOLT LITHIUM-ION CORDLESS MOWER — LM2020SP/LM2020SP-FC/LM2020/LM2020-FC 37

7. Place a metal rod (e.g., a 3.5'' length

screw bit) with diameter less than

1/4'' (6.35mm) into the aligned holes

to act as a stabilizer. Place another

metal rod (e.g., a 3.5'' length screw

bit) with diameter less than 5/16''

(8mm) into the xing hole to act as

another stabilizer (Fig. 28).

8. Use a 9/16'' (14mm) torque wrench

(not included) to tighten the bolt

clockwise. The recommended torque for the blade bolt is 36-43 ft-lb (49-59Nm).

SHARPENING THE BLADE

WARNING:

Always protect your hands by wearing heavy gloves or wrapping

the cutting edges with rags or other materials when performing any maintenance on

the mower blade. Always remove the battery pack when servicing or transporting the

mower.

WARNING:

Use proper eye protection while removing, sharpening, and installing

the blade.

WARNING:

A worn, cracked, or damaged blade can break and pieces of the

damaged blade can become dangerous projectiles. Thrown objects can cause serious

injury. Inspect the blade regularly and do not operate the mower with a worn or

damaged blade.

NOTICE: Keep the blade sharp for best mower performance. A dull blade does not cut

grass cleanly or mulch properly.

A dull blade can be sharpened, but a blade that is excessively worn, bent, cracked, or

otherwise damaged must be replaced. A worn or damaged blade can break, causing

blade pieces to be thrown from the mower.

If the blades are found to be bent, take the lawn mower to an authorized EGO service

center for inspection.

Stabilizer 1

THIS SIDE FACING GRASS

Stabilizer 2

Tighten