Use and Care Manual

56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2020SP/LM2020

REPLACING THE TRAILING SHIELD

WARNING: Always remove the battery pack when servicing

or transporting the mower.

WARNING: Never operate the mower unless the trailing

shield is in place and working. Never operate the mower with

damaged safety devices. Failure to do so can result in personal

injury. The trailing shield is subject to wear and damage, which

could expose moving parts or allow objects to be thrown. For

safety protection, frequently check the trailing shield and replace

it immediately with only the identical replacement part, listed in

this manual.

1. Remove the battery.

2. Turn the mower on its side with the upper surface against

a wall.

3. Remove the rear wheel on the top side, following the

section “REPLACING THE WHEELS” in this manual.

4. For self propel mower LM2020SP, loosen the wheel cover

locking screw and remove the screw, spring washer and

ﬂat washer in that order, then remove the wheel cover from

the wheel shaft (Fig. 33).

5. Repeat steps 1 to 3 above to remove the other rear wheel

and wheel cover (LM2020SP only).

6. Loosen the locking screw for the trailing shield on both

sides; remove the worn trailing shield and the ﬂat washer.

Save the washer for reassembly (Fig. 34a & 34b).

34a

34b

Wheel Axle

Wheel Cover

Locking Screw

Locking Screw For

Trailing Shield

Locking Screw For

Trailing Shield

Trailing shield

For LM2020SP

For LM2020