Use and Care Manual

2556-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2000

NOTICE: To re-install or replace the blade, be sure to replace the

parts in the exact order in which they were removed (Fig. 22).

 Align the inner ange with the shaft and assemble it in

place.

 While wearing protective gloves, position the blade on the

inner ange with the recess (as shown in Fig. 23) toward

the mower.

 While still wearing protective gloves, move the blade by

hand to align the round hole in the blade with the round

pin on the inner ange, and the semi-round hole with the

semi-round pin (Fig. 24).

 Turn the bolt clockwise into the shaft by hand to

pre-tighten.

 Place a metal rod (e.g., a manual screwdriver) into the

xing hole to act as a stabilizer, then use a 9/16 inch

(14mm) torque wrench (not included) to tighten the bolt

clockwise. The recommended torque for the blade bolt is

36-43 ft-lb (49-59Nm) (Fig. 21).

Semi-round Pin and Hole

Round Pin and Hole

Recess