Use and Care Manual

56-VOLT LITHIUM-ION CORDLESS MOWER — LM2000-S/LM2000-S-FC42
PROBLEM CAUSE SOLUTION
The mower
stops while
mowing
◾
The battery pack is depleted.
◾
Charge the battery pack.
◾
Mower is in overload
condition.
◾
Raise the cutting height or slow
down the mowing.
◾
Mower deck is clogged with
grass and debris.
◾
Unclog the mower deck. Raise
the cutting height, or cut a narrow
swath.
◾
The battery or mower
circuitry is too hot.
(The power indicator on the
mower will illuminate orange
for 10 seconds.)
◾
Allow the battery pack or mower
to cool until the temperature drops
below 152°F (67°C).
◾
The side rail is retracted a
little by the pushing force
applying on the handle.
◾
Unlock the clamps. Fully extend the
side rails and lock the clamps again.
The mower
does not mulch
properly
◾
Wet grass clippings are
sticking to the underside of
the deck.
◾
Wait until the grass dries before
mowing.
◾
The mower is set to cut too
much grass at once.
◾
Raise the deck to a higher cutting
height setting.
There is
excessive
vibration
◾
The cutting blade is loose.
◾
Tighten the blade bolt.
◾
The cutting blade is
unbalanced.
◾
Balance the blade following the
instructions.
◾
The cutting blade is bent.
◾
Replace the blade.
◾
The motor shaft is bent.
◾
Contact the service center.
The handle
locking clamps
cannot be
closed in
position
◾
The side rails are not fully
extended.
◾
Fully extend the side rails, then lock
the clamps.