Use and Care Manual

56-VOLT LITHIUM-ION CORDLESS MOWER — LM2000-S/LM2000-S-FC30
SLOPE GAUGE (Fig. 20)
WARNING:
Do not mow a slope that has an angle of greater than 15° (a rise
of approximately 2 1/2’ (0.75m) every 10’ (3m)). Mow across the face of a slope, and
never up and down.
Use Fig. 20 as a guide in order to identify slopes that cannot be mowed safety.
MULCHING TIPS
WARNING:
Inspect the area where the mower is to be used, and remove all
stones, sticks, wire and other debris that might be thrown by the rotating blade.
◾
Release the switch to turn the mower off when crossing any graveled area;
stones can be thrown by a rotating blade.
◾
Set the mower to the highest cutting height when mowing on uneven ground or in
tall growth.
◾
For effective mulching, do not cut wet grass, because it tends to stick to the
underside of the deck, preventing proper mulching of grass clippings. The best
time to mow grass is in the late afternoon when the grass is dry and the newly
cut area will not be exposed to direct sunlight.
◾
For best mulching performance, set the cutting height to remove approximately one
third of the grass blade length, ideally no more than 1 1/2" at one time. If the grass
is overgrown, it may be necessary to increase the cut height to make it easier to
mow and to prevent overloading the motor. Slow your cutting pace in tall or thick
grass conditions. For mulching extremely thick or tall grass, it is advisable to rst
cut at a high cut-height setting, and then re-cut to the nal cut height. Otherwise,
make narrower cuts and mow slowly. ALWAYS MAKE SURE THAT THE BLADE IS
SHARP.