Use and Care Manual

POLE SAW ATTACHMENT — PSA100028
How to Sharpen the Cutters
Be careful to le all cutters (Fig. 18) to the
specied angles and to the same length,
as fast cutting can be obtained only when
all cutters are uniform.
1. Remove the battery pack. Wear
gloves for protection.
2. Properly tension the chain
prior to sharpening. Refer to
the “ADJUSTING THE CHAIN
TENSION” section earlier in this
manual.
3. Use a 0.177" (4.5 mm) diameter
round le and holder (available
separately). Do all of your ling at
the middle position of the guide bar.
4. Keep the le level with the top plate
of the tooth. Do not let the le dip or
rock.
5. Keep a correct sharpening angle of
30° between the le and the saw
chain; see Fig. 19 & 20. Always use
a le holder (available separately)
when sharpening saw chains by
hand. File holders have markings for
the sharpening angle.
6. Using light but rm pressure, stroke
towards the front corner of the tooth. Lift the le away from the steel on each
return stroke.
20
18
Top Plate
Side Plate
Depth Gauge
19
0.177" (4.5 mm)
Round File
Filing Direction
Cutter tooth
Sharpening
Angle: 30°