Use and Care Manual

56V LITHIUM-ION CORDLESS EDGER — ED0800/ED0800-FC 27
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Motor fails to start.
◾
The battery pack is not
attached to the edger.
◾
Attach the battery pack to the edger.
◾
No electrical contact
between the edger and the
battery pack.
◾
Remove the battery, check contacts
and reinstall the battery pack until it
snaps into place.
◾
The battery pack is
depleted.
◾
Charge the battery pack with EGO
chargers listed in this manual.
◾
The lock-off button and
trigger are not depressed
simultaneously.
◾
Press down the lock-off button and
hold it, then depress the trigger to
turn on the edger.
Edger stops during
operation.
◾
The motor is overloaded.
◾
The motor will recover when the load
is removed. For continuous working,
decrease the load on the edger.
◾
The battery pack or the
edger is too hot.
◾
Allow the battery pack or edger to
cool until the temperature drops
below 152°F (67°C).
◾
The battery pack is
disconnected from the tool.
◾
Re-install the battery pack.
◾
The battery pack is
depleted.
◾
Charge the battery pack with EGO
chargers listed in this manual.
Uneven edge.
◾
Grass or soil edged is too
wet.
◾
Avoid edging in wet soil or wet
grass.
◾
Blade guard is clogged.
◾
Stop the motor, remove the battery
pack, and remove debris from the
blade guard.