Use and Care Manual

56V LITHIUM-ION CORDLESS EDGER — ED0800/ED0800-FC 23
To install the blade
1. Remove the battery pack.
2. Position the inner ange removed in
step 6 of the “To remove the blade”
section onto the motor shaft with
the bulge of the inner ange facing
outwards (Fig. 15).
3. Install the new blade onto the inner
ange.
WARNING: The bulge of the inner
ange must engage the blade’s mounting
hole (Fig. 16). There should not be any
clearance between the blade and the
inner ange at surface.
4. Mount the outer ange and the nut
onto the shaft, and pre-tighten the
nut COUNTERCLOCKWISE by hand.
5. Rotate the blade to align the slot in
the ange with the hole in the gear
case (see Fig. 12).
6. Insert the hex wrench provided
into the aligned holes to act as a
stabilizer. Use the multi-function
wrench provided to tighten the nut
COUNTERCLOCKWISE securely onto
the shaft (Fig. 17).
7. Insert a new cotter pin into the hole in the motor shaft. Bend the two ends of the
pin in opposite directions with a needle nose pliers (not included) (see Fig. 12).
17
Stabilizer
Multi-function
Wrench Provided
15
Bulge Outwards
16
Inner Flange
Blade
Bulge of the inner ange
engaging the blade