Use and Care Manual

56V LITHIUM-ION CORDLESS CHAIN SAW — CS1600/CS1600-FC 47
PROBLEM CAUSE SOLUTION
Chain saw does
not cut properly.
◾
Insufcient chain tension.
◾
Readjust the chain tension, following
the section: “ADJUSTING THE
CHAIN TENSION”.
◾
Dull chain.
◾
Sharpen the chain cutters, following
the section: “HOW TO SHARPEN
THE CUTTERS”.
◾
Chain installed backwards.
◾
Reinstall the saw chain, following
the section: “REPLACING THE BAR
AND CHAIN”.
◾
Worn chain.
◾
Replace the chain, following the
section: “REPLACING THE BAR
AND CHAIN”.
◾
Dry or excessively stretched
chain.
◾
Check the oil level. Rell the oil tank
if necessary.
◾
Chain not in bar groove.
◾
Reinstall the saw chain, following
the section: “REPLACING THE BAR
AND CHAIN”.
Bar and chain
running hot and
smoking.
◾
Check chain tension for over
tightened condition.
◾
Re-tension the saw chain; see the
section: “ADJUSTING THE CHAIN
TENSION”.
◾
Chain oil tank is empty.
◾
Filling bar and chain lubricant.
◾
Debris in guide bar groove.
◾
Clear the debris in the groove.