User`s manual

S5 is used to activate the “omni” mode. “Omni” is a special mode that allows the M4 to receive
data on all 16 midi channels simultaneously. Turning the omni mode on overrides S1 through S4.
Set actuator 5 ON to turn the “omni” mode on or up for off.
S6 is the “Program change enable” function. This is the most common mode of operation that
allows the M4 to receive program change (patch) commands from your midi controller. Set this
switch down for on or up for off.
S7 is the “Controller data enable” function. Activating this mode allows the MOD100 to respond to
instant access data from midi controllers. Below are the “note / controller” numbers that will turn
on the modules.
Note Module
#56 ……… 1A
#57 ……... 1B
#58 ……… 2A
#59 ……… 2B
#60 ……… 3A
#61 ……… 3B
#62 ……… 4A
#63 ……… 4B
#64 ……… MUTE ALL
S8 has no function at this time.
PAGE 8 END