User`s manual

PAGE 1
SPECIAL NOTES:
PROGRAMMING CHANNELS:
The MOD100 comes preprogrammed with the six sounds
(two per module) corresponding to buttons one through six
on the EGNATER pedal or program patch numbers one
through six on a midi controller. This can be easily changed.
To do so, simply select the desired program or patch number
on your pedal. Next, select the module/channel using the
CHANNEL button. Now press and hold the CHANNEL button
for three seconds. The channel on LEDs will flash indicating
the new setting is now stored. This can be repeated for up to
128 midi patches.
PHANTOM POWER:
9VAC@1amp power is supplied to the pedal through the
7 pin FOOTSWITCH IN jack. The power is active on pins 1 &
3 and 6 & 7. Please refer to your midi pedal manual to verify
your pedal is compatible with the supplied power.
MASTER DENSITY AND PRESENCE:
These knobs provide BASS and TREBLE boost in the power
amp section of the MOD100. Similar in effect to the
“loudness” contour on your home stereo, at low volume,
fullness and clarity is enhanced. These powerful controls
should be used sparingly at high volumes. At higher volume,
if overused, the sound can get muddy or brittle. Tighter,
punchier bass will be achieved with the lowest possible
settings of the density control.