Instructions / Assembly

5
Care and Cleaning
Allow the light xture to completely cool before touching.
To clean the xture, rst disconnect power to the xture by turning off the circuit breaker or by removing
the fuse at the fuse box.
Use a clean cloth, dry or slightly dampened with water (never use a solvent) to wipe the entire xture.
Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or
wipe carefully.
Troubleshooting
Problem Possible Cause Solution
The bulb will not
light.
The power is off. Ensure the power supply is on.
The switch on the xture is in the “off
position.
Flip the switch on.
There is a faulty wire connection. Check the wiring.
The switch is faulty. Test or replace the switch.
The fuse blows or
the circuit breaker
trips when the light
is turned on.
There are crossed wires, or the power wire is
grounding out.
Check the wire connections.
Contact a qualied licensed
electrician.
NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15B of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no gurantee that interference will not occur in a particular installation. If this equipment
does cause harmful inerference to radio or television reciption, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between he equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is conected.
Consult the dealer or an experienced radio/TV technician for help.