User's Manual

EWB160031M User manual
Proprietary & Confidential Information Egis Technology Inc.
Doc. NO:
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could
void the user’s authority to operate the equipment.
15.105(b) for Class B Device (usual)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded
interface cables when connecting to computer or peripheral devices).
End Product Labeling
This transmitter module is authorized only for use in devices where the antenna may be installed such that 20cm may be
maintained between the antenna and users. The final end product must be labeled in visible area with the following:
“Contains FCC ID: 2A84HEWB160031M”
End Product Manual Information
The user manual for end users must include the following information in a prominent location “IMPORTANT NOTE:
To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to
provide a separation distance of at least 0.5 cm from all persons and must not be collocated or operating in conjunction
with any other antenna or transmitter.” This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions (1) This device may not cause harmful interference and (2) This device must accept any
interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or colocation with another
transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final
product. In these circumstances, the OEM integrator will be responsible for reevaluating the end product (including the
transmitter) and obtaining a separate FCC authorization.
This devisees intended onlt for OEM integrators under the following conditions: The antenna must be installed such that
20cm is maintained between the antenna and users. As long as a condition above is met, further transmitter test will not
be required. However, the OEM integrator is still responsible for testing their end product for any additional compliance