User's Manual

EWB160031M User manual
Proprietary & Confidential Information Egis Technology Inc.
Doc
. NO:
10.Appendix
Compliance with
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting condition or different operational
conditions (example, uses another antenna) for a stand-alone modular transmitter in a host, host manufacturer have to consult with module
manufacturer for the installation method in end system.
2.4 Limited module procedures
This module is single modular. 
Not applicable.
2.5 Trace antenna designs
Not applicable.
2.6 RF exposure considerations
This modular transmitter should be used in the mobile conditions and 20cm from a person’s body, the host product manufacture should be put
those information in the end-product manual to the end users. If RF exposure statement and use conditions are not provided, then the host product
manufacture is required to take responsibility of the module through a change in FCC ID(new application)
2.7 Antennas
This radio transmitter FCC ID : 2A84HEWB160031M and has been approved by Federal Communications Commission to operate with the
antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the
maximum gain indicated for any type listed are strictly prohibited for use with this device.
Manufacturer Part No. Antenna Type Maximum antenna gain
IOTTECH EWB160031M PCB Antenna
-0.27dBi for 2.4GHz
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID: 2A84HEWB160031M.
2.9 Information on test modes and additional testing requirements
Host manufacturer which install this modular with approval should perform the test of radiated emission and spurious emission according to FCC
part 15 :15.212 requirement, only if the test result comply with FCC part 15.212 requirement, then the host can be sold legally. When testing
host product, the host manufacture should follow FCC KDB Publication 996369 D01 Module Integration Guide for testing the host products. The
host manufacturer may operate their product during the measurements.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable requirements for the system
such as Part 15 B.