User`s manual

- 42 -

Appendix C - Sample Flight Settings

Low-to-Medium Power Non-Deployment Example

These settings will work fine for a small D-size rocket, or most E-G rockets. If the rocket is

heavy, you might want to take the Burn/Coast sample rate down a notch, to 5.

Eggtimer Build_1.45 Flight Settings

T:23.50

A 100 LDA <50-500 by 50> P:97804.00

B 8 Burn/Coast Samp/sec: <4,5,8,10,15,20,25,33> A:975.39

125 Interval (ms) Main:0

C 2 Descent Samples/sec <1,2,4,5,10> CHB:0

500 Interval (ms) Batt:3.12

D 0 Main Enable <0-Off, 1-IGN, 2-Servo CCW, 3-Servo CW>

E 300 Main Altitude <100-2000 by 50, 0 @ Apogee>

F 2 Main ON-Time <1-9,0-Cont.>

G 0 CHB Enable <0-Off, 1-IGN, 2-Servo CCW, 3-Servo CW, 4-Airstart>

H 2 CHB ON-Time <1-9,0-Cont.>

I 1 Burn Timer <1-20>

J 0 Airstart Delay <0-9>

K 0 Telemetry

O Comments: MPR non-deployment example

Options: Esc, A-O, ?

Low-Medium Power Multiple Deployment Example (Using Motor’s Ejection)

If you add multiple deployment to the example above, you probably don’t need to change the

sample settings, but you obviously will need to set the deployment options. This example

deploys the main chute at 300 feet, and fires for 2 seconds. The motor’s ejection fires the

drogue, so you don’t need to set Channel B.