User`s manual

- 23 -
Eggtimer TRS
Eggtimer TRSEggtimer TRS
Eggtimer TRS 1.
1.1.
1.4K
4K4K
4K Flight Settings
Flight Settings Flight Settings
Flight Settings
MY EGGTIMER
MY EGGTIMERMY EGGTIMER
MY EGGTIMER
T:23.50
T:23.50 T:23.50
T:23.50
P:97804.00
P:97804.00 P:97804.00
P:97804.00
A 1 Drogue <0=OFF,1=Nose
A 1 Drogue <0=OFF,1=Nose A 1 Drogue <0=OFF,1=Nose
A 1 Drogue <0=OFF,1=Nose-
--
-Over,2=Backup> A:975.39
Over,2=Backup> A:975.39Over,2=Backup> A:975.39
Over,2=Backup> A:975.39
B 700 Main Altitude <100
B 700 Main Altitude <100 B 700 Main Altitude <100
B 700 Main Altitude <100-
--
-2000 by 50, 0=OFF> Main:1
2000 by 50, 0=OFF> Main:12000 by 50, 0=OFF> Main:1
2000 by 50, 0=OFF> Main:1
Drogue:1
Drogue:1 Drogue:1
Drogue:1
Batt:7.74
Batt:7.74 Batt:7.74
Batt:7.74
900 Frequency (Ctrl
900 Frequency (Ctrl 900 Frequency (Ctrl
900 Frequency (Ctrl-
--
-F to Change)
F to Change)F to Change)
F to Change)
0 ID Code
0 ID Code 0 ID Code
0 ID Code
Options: Letter to Change, ESC to Save
Options: Letter to Change, ESC to Save Options: Letter to Change, ESC to Save
Options: Letter to Change, ESC to Save
Options are selected by hitting the letter in front of the value, then using the + and – keys to toggle
the values up and down by the increment value (for example, 50 for the LDA setting, 1 for most
other settings). If the numeric value can be above 10, you can step up by 10 times the increment
value by hitting the “>” key. Similarly, you can step down by 10 times the increment value by
hitting the “<” key. The Esc key (usually in the upper left corner of your keyboard) exits the screen
and saves the flight settings, you will hear a long beep that confirms the save and then the Eggtimer
will halt (both lights will blink continuously). The ? key allows you to download saved flight data
(more on that later). Finally, there are a few “hidden” keys for special functions, such as erasing all
the flight memory and setting the flight settings to defaults, these are covered in the Appendix.
Note that if you do not hit ANY keys, the Eggtimer TRS assumes that you don’t have a PC
connected and you are ready to start a flight. The beep-beep that tells you that you are in
programming mode lasts for 30 seconds, then the Eggtimer begins the flight sequence. For this
reason, if you ARE programming it you should hit Enter a few times to let it know that you have a
terminal connection; once you do, it will terminate the flight sequence and save your settings and
halt after you are done programming.
Note: When you first get your Eggtimer TRS, the flight memory is NOT initialized.
Please see Appendix A for instructions on how to clear the flight memory by
performing a Master Reset. You will need to do this before you can program or fly
the Eggtimer TRS, or unpredictable results may follow!
Field Descriptions:
A Main Altitude <50-1200 by 50, 0=OFF>