User`s manual

- 19 -
This setting turns the Drogue channel off, for example if you were going to use motor-deploy
for the drogue or even the main chute for a single-deploy project. Note that when the Drogue
channel is OFF you will still get a drogue continuity display, but it will ignore the drogue
channel when checking to see if you’re ready to fly.
To select the displayed value, PRESS the button for at least 1 second, it will beep to confirm
your selection and you’ll see the next item that can be changed.
This is the Main deployment channel’s status. The value that’s displayed here is 500 feet, so the
Main channel will fire at 500 feet or so. To change it, PRESS the button for at least 1 second,
you’ll see the “?” that means you’re in CHANGE mode…
If you TAP the button, the value will increment by 50 feet. If you keep tapping the button, it will
keep incrementing until it reaches the maximum value (1200 feet). If you TAP it again, you’ll
see this:
This turns OFF the Main channel, which means that it won’t fire at all. This would be
appropriate if you were going to use motor-deploy with a single parachute, or if you were going
to use the Drogue channel to deploy a single parachute near apogee. When the Main channel is
OFF, you will still get a main continuity display, but it will ignore the main channel when
checking to see if you’re ready to fly.
If you TAP the button from here, it will cycle to the minimum value (50’, not recommended
unless you REALLY know what you’re doing…), and subsequent taps will increment by 50’.
When you see the value you want, PRESS the button for at least 1 second, you will hear a beep
to confirm your selection, then you’ll see the next screen…
Drogue
?OFF
Main:OFF,50-1200
500
Main:OFF,50-1200
?500
Save Options
Main: OFF, 50-1200
?OFF