User`s manual

- 14 -
This is the standard Eggtinder LCD “welcome” screen, and it will be displayed for about 5
seconds. You will then see this screen:
This is the Eggfinder LCD status screen, that tells you what your Eggfinder LCD receiver’s
current settings and battery voltage are. If you hold the button down for about 2 seconds and
release it, you can change them; however, you should not do that while you are trying to pair
with your Eggtimer TRS unit! See the Instructions in the Eggfinder LCD Users Guide for more
details.
Assuming that you do nothing, after about 10 seconds you will see this screen:
This tells you that the Eggfinder LCD is waiting to hear the “beacon” from the Eggtimer TRS
unit. After a few seconds, you should see this screen:
This screen is your confirmation that the two units have paired up. It shows you the software
version of the Eggtimer TRS, and the Device Name that you gave the unit in the Frequency
Setup screen. (More on that later). The Device Name is your confirmation that it’s YOUR
Eggtimer TRS that it’s paired up with, and not somebody else’s. Since there are 72 possible
frequency/ID combinations, it’s unlikely that anyone else would be on yours (unless neither of
you changed it from the default!).
At this point, the two are in sync… tap the button to continue.
Status: 915 0
GPS
:D Alt:F
6.4V
Waiting for Sync
Eggtimer TRS 4K
MY
EGGTIMER TRS