Specifications

this lets you know that it’s in programming mode. Press A B C D A B C D, you should then
hear three beeps again to let you know that the code “took”.
__ Wait about 10 seconds, then press A B C D A B C D. You should hear three beeps,
then the red “ON” LED should come on. This confirms that the switch is working. Wait about
10 seconds, then press A B C D A B C D again. You should hear TWO beeps to let you know
that it’s turning off, and the red “ON” LED should turn off.
At this point, congratulations! You’re done. Read on for a detailed explanation of how to
hook it up to your electronics and how to use it. If you’re a bit impatient and want the 10-
second tutorial, jump to the Quick Reference Guide at the end of this manual… if you get
stuck, though, you just might end up reading the long version anyway!
If you do NOT get the right beeps and lights, you have some work to do. You’ll have to
GENTLY bend the RF module board away from the Remote Switch PC board, and check the
solder joints on components. Pay close attention to the components that have the smallest
clearance, they are most likely to be the ones causing problem.