User's Manual

NOTE: The camera can also be placed on a flat surface, such as a Table or Shelf, and no mounting

hardware is required.

3. Adjust the viewing angle of the camera

NOTE: You can install additional cameras (maximum of 4 cameras). When adding cameras that were

not included in the original box, you will need to pair up the cameras with the receiver. Refer to the

camera pairing section of this manual.

Installation Warnings

Aim the camera(s) to best optimize the viewing area: Select a location for the camera that provides a

clear view of the area you want to monitor, which is free from dust, and is not in line-of-sight to a strong

light source or direct sunlight.

Avoid installing the cameras where there are thick walls, or obstructions between the Cameras and the

Receiver.

Do not install camera in those area which is easy for baby to touch; Make sure the camera is installed

stable and not fall down.

Connecting Camera Power

The camera can be powered either by using the provided power adaptor, or using batteries (requires 4

AA type batteries, not included).

NOTE: Wireless cameras require a power source (either an electrical outlet or battery power) to operate.

If you plan to permanently mount the camera in a location, it is recommended to use the included

camera power adaptor to prevent interruptions in the image, as using battery power is intended as a

temporary power solution.

Power Adaptor

Connect the power adaptor to the camera. Make sure the

power adaptor is placed into a grounded outlet or surge bar

to protect the camera from power fluctuations.

Battery Pack

1. Remove the battery cover off the base of the camera.

2. Insert 4 AA batteries (not included) into the Battery Pack.

Make sure to correctly line up the Positive (+) and negative

(-) terminals of the batteries.

3. Place the battery pack cover back on.

NOTE: If the camera is plugged in with the AC adaptor, the

batteries will not be used. The batteries are intended for

short term, portable camera use only.