Owner's Manual

INSTALLATION
INSTRUCTIONS
(cont'd)
GROUND CONNECTIONS
IMPORTANT NOTE:
The supplied ground wires are pre-cut at
an
optimum length
of
2
ft. as
well
as pre-terminated with exclusive (pat. pending) Ultimate Ground Terminals
(UGl). These
UGTs
provides fast installation, maximum contact and the
most reliable
connection. Use the provided self-tapping screws
to
mount
each terminal use
BOTH
screws.
FIGURE
4
ULTIMATE GROUND
TERMINAL
1. Located a good chassis ground point (clean bare metal) for your
amplifiers within
(2
ft.)
reach
of
each amplifier. Be sure
to
check for
obstructions around and behind the surface area aournd your
chassis ground. Use the
(2)
included self
tapping screws to tightly
secure the terminal (see Figure
4).
2. For
amplifiers
without insert power terminals, crimp the
supplied
BGA
spade terminal (Black boot)
to
the opposing end
of
the
ground
cable
and connect
to
your
amplifiers
(-12V) ground
Input
(see Figure
3,
page
3).
3.
Repeat steps 1-2 above for amp 2.
REMOTE
TURN
ON
Cut
the existing Remote turn-on wire near the current
amplifier's
location.
Strip both ends
of
the wire. Use the
supplied
RED
butt-splice connector and crimp the end
coming from the car stereo
in
one side
of
the butt con-
nector. Twist the other end
of
the remote turn on wire
and the new 6
ft.
BLUE turn on wire
in
142PAD8BX
and crimp into the opposite end
of
the butt connector
(see Figure
5).
Route the other end
of
the new Remote
Turn-on
lead
to
the new amp and connect using a
supplied 18-22GA Red
~pade
terminal.
~
SCREWS
~
(Included)
FIGURE 5
REMOTE TURN-ON WIRE
RCA INTERCONNECTS
We
recommend routing the
Core
twisted interconnect
cable along
with the existing amplifier
RCA
cable.
~
..
DCJD
..
Connect
the
leads
to
an open set
of
audio outputs.
Make the same connections at the new
amplifier.
INSTALLER NOTE: If your stereo does not have and extra or unused set
of
RCA
outputs, then additional parts (not
included) are required.
We
recommend either adding a set
of
Y-Adapter cables (which
will lose
Fade capability)
or
use
of
a line-output converter. The
line out convertor
will step-down standard speaker outputs into RCA outputs.
Contact
the
Scosche sales
team for further information:
1-800-621-3695
Ext.1.
Your
installation
of
this
Dual Amplifier Add-on Installation Kit
is
now complete.
Install
all
in-line fuses and reconnect
the negative battery wire. For Technical
Support
or
any further questions
feel
free to contact the
Scosche
Tech
Support
team at:
1-800-621-3695
Ext.3.
LIMITED
WARRANTY
Scosche Industries Inc.
warrants this product
to
be free from defects in material and workmanship for a period
of
1 year from date
of
purchase.
DOA
units can be returned
to
the
selling retailer
for exchange. Units that have been
installed
for more then 30
days must
be sent back
to
Scosche
for repair. Consumers must
call
the Scosche 800
number for an RA number and pay
to
ship the unit back
to
Scosche. Scosche
will
then repair
or
replace the unit at our discretion and pay shipping cost
to
return unit back
to
customer. This
warranty does not cover any expenses incurred in removal and
reinstallation
of
the product in the vehicle. This warranty is offered
to
the original purchaser
of
the product only. This warranty does not apply
to
product which has been water
or
physically
damaged,
damaged by accident
or
which has been misused, disassembled or altered,
or
installed improperly.
If
the product should prove
defective within the warranty period, return the product with a copy
of
the sales slip, postage prepaid to: Scosche Industries Inc., 1550
Pacific Ave., Oxnard CA 93033, Attn:
Service
Dept.
Your dated sales slip will
establish your warranty
eligibility.
Scosche, at our option
will
repair
or
replace the product free
of
charge and
will
return the product
to
you postage paid.
In
no event
shall
Scosche be responsible for claims beyond the replacement value
of
the
defective product
or
in any way be held liable
or
responsible for consequential
or
incidental damages. No expressed warranties and no
implied warranties, whether for fitness
or
any particular use,
or
otherwise, except as set forth above (which is made expressly in lieu
of
all
other warranties) shall
apply
to
products sold by Scosche. No waiver, alteration, addition
or
modification
of
the foregoing conditions
shall
be valid unless made in writing and signed by
an
executive officer
of
Scosche Industries Inc.
No salesperson, representative,
or
agent
of
Scosche
is authorized
to
give any guarantee, warranty,
or
make any representation contrary
to
the above.
4