Owner's Manual

~~/
~~ ~
DUDB4
@scosc:::1-11=
DISTRIBUTION BLOCK INSTRUCTIONS
The block has O to 4 gauge input adapters and
4 to 8 gauge output adapters pre-installed in the
wire terminals. To Change from the smaller to the
larger gauge simply loosen the set screw until
the adapter can be removed from the terminal
(see illustration).
The DUDB4 can be used in two different ways:
1. As a 1-in/4-out power distribution block
2. As a combination 1-in/2-out power and
2-in/1-out ground block
1. SETTING UP AS A 1-IN/4-OUT
DISTRIBUTION BLOCK
Unscrew and remove one of the terminal inputs
from the distribution block (A). Second, remove
the negative conversion plate (B). Third, align
center and secure the second terminal input
to the distribution block (C) . Fourth, install
the correct fuse values recommended by the
amplifier manufacturer (D). Lastly, reinstall the
cover plate.
E
Negative
Conversion Plate
D
Fuses
(Not included)
□
WIRE GAUGE ADAPTER
( pre-installed)
□
@@@@
F
Fuses
(Not Included) -
2. SETTING UP AS A COMBINATION
POWER/GROUND DISTRIBUTION BLOCK
First, make sure the metal negative conversion
plate is installed into the two left or two right fuse,
depending on which side you wish to use for
ground (E). Second, install the correct fuse values
recommended by the amplifier manufacturer (F) .
Lastly, reinstall the cover plate.
If you have any further questions, call us at 1-800-363-4490 x1 or visit us online at www .scosche.com/contact
EFX IS A DIVISION OF SCOSCHE INDUSTRIES , INC . ©2009 SI 05/19 - 300DUDB4