User Guide

Revision: 1 Date: 2004.03.25 (Manufacturing Section): PE
Explanation of illustrations
Difference Operating item Part name/specification Part/number Q'TY Operation description Important note Jig/fixture
HYUNDAI LCD LCD-12.1" XGA TFT-HYUNDAI-HT12X12 72-112230-30
TOSHIBA LCD LCD-12.1"-TFT XGA-TOSHIBA-LTD121EA41 72-11223G-10
HYUNDAI LCD
LCD-12.1"-XGA TFT-HYUNDAI-HT12X12-
TRIGEM CSG
72-112230-30TRI
2 Key parts label N/A 1 Attach key parts label N/A barcode machine
HYUNDAI LCD N222S1-HARNESS FOR HYUNDAI 12.1"-SH650 29-001650-03
TOSHIBA LCD N222S1-HARNESS FOR HSD 12.1" LCD-SH640C 29-001640-01
4 N222S8P-MYLAR FOR LCD HARNESS 50-023324-00 1
Place white Mylar in between LCD wires and LCD
Panel
All LCD wires must be on white
Mylar
N/A
5 Wide, white tape (2X4cm) 93-000256-20 1
Attach tape to LCD wires and LCD connector as
shown in the diagram.
N/A N/A
6
ELECTRICAL TAPE 3M NO E17385
W=10mm(1X6cm)
61-080022-00 2 Attach tapes on LCD wires as shown in the diagram. N/A N/A
7 E12B SPONGE-R FOR LCD 51-036240-00 1 Attach sponge as shown in the diagram. N/A N/A
8 E12B SPONGE-L FOR LCD 51-036241-00 1 Attach sponge as shown in the diagram. N/A N/A
N/A
(Twinhead S.O.P) (Document NO): TESOP388
Working name: 6512-4
Name of SOP: efio!121i LCD MODULE ASS'Y SOP
PAGE: 05
1 1
N/A13
Attach LCD HARNESS on LCD connector as
shown in the diagram
N/A
Check LCD panel to make sure there are no
scratches.
N/A
1
5
4
3
6
Attach along iron
slice edge; tape
must not extend
over iron slice.
2
13m
m
8
10m
m
7
Twinhead International Corp.