User Guide

Revision: 1 Date: 2003.10.14 (Manufacturing Section): PE
Difference Operating Item
Part name/specification Part/number Q'TY Operation description Important note
Jig/fixture
SCREW ISOP M2.0 X 6.0L 41-850520-06
3NA NA 1
Arrange wires: Place LCD's wires under bottom dent
理;connect LCD wires to M/B.
Arrange wires as shown in diagram. N/A
PAGE: 15
Name of S.O.P﹕efio!121A System Ass'y SOP
Working name: 7009
1
#8028 DISPLAY ASS'Y-12.1" XGA
TFT-FOR HYDIS-D21
86-636905-10 1
Explanation of illustration
Electrical screwdriver/Torque:
2.0±0.5Kgf-cm
Tighten HINGE SCREW on upper cover in a.b. order as
shown in diagram. Open LCD at both hinges and shake
3-4 times before tightening.
Before locking the screws, make sure the
LCD does not rise up at an angle to the base
.
( Twinhead S.O.P ) (Document NO) : TESOP260
Take LCD, wipe BARCODE and install LCD
MODULE on BASE MODULE
Do not damage upper cover when
assembling. When installing LCD, make
sure both hinges are installed at the same
angle
bar code machine
22
3
1
Twinhead International Corp.
a
b
2
Both hinge must be installed
horizontally