User Guide

Revision: 1 Date: 2003.10.14 (Manufacturing Section): PE
Difference Operating Item Part name/specification Part/number Q'TY Operation description Important note Jig/fixture
WIRELESS LEN MODULE 76-070005-00 1
KEY PARTS LABEL 63-250190-00 1
PRODUCT BAR CORD LABEL 63-000710-00 1
2NA NA 1
Plug wireless antenna into transmission card as shown
in diagram.
C
onnect as shown in diagram.
NA
3 P22T rubber for wireless 52-003091-00 2
Attach 2 rubber pieces to wireless card as shown in
diagram
When attaching rubber, do
cover card's edge or
card's electrical parts.
NA
4 SCREW ISOT-M2X3L-SELF-LOCKING 41-721520-03 2
Tighten two screws (M2X3) on wireless transmission
card and fix it on M/B
When tightening, make sure
rubber doesn't not extend
over card's edge
Electrical screwdriver/Torque:
1.5±0.5Kgf-cm
PAGE: 12
1
Plug wireless card wire into M/B. Attach KEY PARTS
LABEL and PRODUCT BAR CORD LABEL on M/B
as shown in diagram. Wipe BARCODE
BAR CODE machine
NA
5 Tape, narrow size (around 3~4cm) 61-080022-00 2
( Twinhead S.O.P ) (Document NO) : TESOP260
Name of S.O.P﹕efio!121A System Ass'y SOP
Working name: 7008
Explanation of illustration
Attach 2 pieces of tape to fix wires as shown in
diagram.
Wires must be attached
flat on board; do not band
NA
Twinhead International Corp.
Plug wires from
here
2
3
1
4
Plug wireless antenna
into transmission card
at 45 degree angle
5