User Guide

Revision: 1 Date: 2003.10.14 (Manufacturing Section): PE
Difference Operating Item
Part name/specification Part/number Q'TY Operation description Important note
Jig/fixture
1
Tape, narrow size (around 2~3cm)
61-080022-00 2
Arrange wires at bottom cover plow, use 2 pieces of tape to
fix it as shown in diagram.
NA
Tape holder
P22AJ-PCB ASS'Y-VI-USB-REV: D
80-690000-00D 1
P22AJ-PROTECT RUBBER FOR
USB-7.6x4x1.7t-E46220
52-002082-00 2
3
AL WASHER FOR USB BOARD-
OD=8,ID=3,T=0.2mm
41-690130-02 1
Attach aluminum foil to USB card's left upper side as
shown in diagram.
Aluminum foil must align with hole NA
4
AL WASHER FOR USB BOARD-
OD=8,ID=3,T=0.3mm
41-690130-03 1
Attach aluminum foil to USB card's right lower side as
shown in diagram.
Aluminum foil must align with hole NA
5
NA
NA 1
Connect USB card and fix it at bottom cover right side as
shown in diagram.
NA
NA
Explanation of illustration
PAGE: 07
( Twinhead S.O.P ) (Document NO) : TESOP260
Name of S.O.P﹕efio!121A System Ass'y SOP
Working name: 7054
2
Get a USB card; attach 2 pieces of rubber to USB cards
shown in diagram.
NA
NA
Twinhead International Corp.
5
1
2
3
Arrange wires in plow. Do
not place tape in CD-ROM
assembly area. Tape must
not extend over base edge.
When assembling RJ11,
place side of MYLAR
with writing in place first;
do not damage MYLAR
4