Installation guide

18 Bridge Configuration Efficient Networks
4 At the FTP command prompt, type in: binary
5 You can upload a new revision of firmware by changing to the
directory where the file is stored and entering the command
put
5600.img
6 The command prompt will return when the router has finished
programming the firmware into memory.
Bridge Configuration
Because the 5600 is configured by default in router mode, it must be set to
bridge mode in order to function as a bridge.
Step 1: Changing Modes
You can choose one of two methods to change the router to function in
bridge mode, the web interface or the command line interface.
Changing to Bridge Mode through the Web Interface
1 Start your web browser
2 Enter the router’s IP address: 10.0.0.1
3
On the first page, click on the link, “Change to Bridge Mode”.
4 When the display appears, click on the radio button labeled Bridge.
5 Click on the button, Change Mode
6 When the response appears at the bottom of the screen, it will include
a link that says “
REBOOT REQUIRED”. Click on that link and choose
yes to reboot the router. Select Refresh after a minute to see the new
configuration.
Changing to Bridge Mode through the Command Line
Interface
The command line interface is designed for use by advanced users. Refer
to “Command Line Interface” on page 26 for more information about the
command line. Detailed instructions for using the command line interface