Installation guide

Efficient Networks Router Configuration 15
3 The browser displays the router’s management interface.
4 On the main page, click on Simple Setup.
5 If your service provider has specified a VPI/VCI number to use, enter
the numbers in the
VPI and VCI fields.
6 Enter the PPP Username and Password issued by your service
provider.
7 Click the Set button. This will set the new VPI/VCI parameters on the
router. Refer to “Web Interface” on page 25 for more information on
configuring the router via the web interface.
Creating a Virtual Circuit using RFC 1483 Encapsulation:
1
Start your web browser
2 Enter the router’s IP address: 10.0.0.1
3
On the main page, look in the Configuration Summary table and click
on the title
Encapsulation Protocol.
4 Click the button for the type of virtual connection (VC) you want to
create.
5 If your service provider has specified a different VPI/VCI number to
use, enter the numbers in the
VPI and VCI fields. Otherwise, enter the
default VPI and VCI values.
6 Select the desired RFC 1483 multiplexing method (LLC or VCMUX).
7 Select Max as the rate.
8 If you are not using DHCP, enter an IP address and a default gateway
that is on the same IP subnet as the WAN IP.
9 Click the Submit button to set new parameters or select Default VC to
reset the default configuration for the selected encapsulation protocol.
10 When the response appears at the bottom of the screen, it may
include a link that says “
REBOOT REQUIRED”. If so, click on that
link and choose
yes to reboot the router.