User`s guide

SpeedStream Wireless DSL Gateway Installation
13
1. Connect the USB Cable
1) With your computer off, connect the provided USB cable to the USB port on the SpeedStream
Gateway.
2) Connect the other end of the USB cable to an open USB port on your computer.
3) If desired, use standard 10/100 CAT5 Ethernet cables to connect additional computers to the
Ethernet ports on the rear of the Gateway.
2. Connect the DSL Cable
1) Connect the DSL cable (resembles a telephone cord) to the DSL port on the rear of the Gateway.
2) Plug the other end of the DSL cable into the phone jack.
3. Connect the Power
1) Connect the power adapter to the rear of the Gateway.
2) Plug the power adapter into the electrical wall outlet.
3) Flip the power switch to power on the Gateway.
4) Power on all connected computers.
4. Install USB Driver Software
1) Insert the SpeedStream Gateway driver CD-ROM into the CD-ROM drive of your computer.
2) When prompted, follow the on-screen instructions to complete the driver installation.
3) No driver software is required for computers connected to the Gateway using Ethernet cables.
5. Check the LEDs
• The DSL, USB, and Power LEDs should be lit. (For more information, refer to LEDs in
Chapter 1, Introduction.)
USB Driver Installation (Macintosh Systems)
When using the USB installation method on a Macintosh, follow these steps to install the USB drivers:
• Macintosh Classic (versions 8.6, 9.x)
1. To “unstuff” the installer to the EFNTClassic110 directory, run EFNTClasic110.sit
2. In the English directory, run the SpeedStream 5x OS9 Installer-en
- or -
In the French directory, run the SpeedStream 5x OS9 Installer-f2
• Macintosh OS X (versions 10.1.x, 10.2.x)
1. To “unstuff” the installer to the EFNTOSX110 directory, run EFNTOSX110.sit
2. In the EFNT0SX110 directory, run the SpeedStream 5x Installer