User`s guide

SpeedStream Wireless DSL Gateway Installation

2. Connect the DSL cable:

1) Connect the DSL cable (resembles a telephone cord) to the DSL port on the rear of the

SpeedStream Gateway.

2) Plug the other end of the DSL cable into the phone jack.

3. Connect the power:

1) Connect the power adapter to the rear of the SpeedStream Gateway.

2) Plug the power adapter into the electrical wall outlet.

3) Flip the power switch to power on the SpeedStream Gateway.

4) Power on all connected computers.

4. Check the LEDs:

1) For each active Ethernet connection, the LAN Link LED for the corresponding port number

should be lit.

2) The DSL and Power LEDs should be lit. (For more information, refer to LEDs in Chapter 1.)

When using the Ethernet installation method, you do not have to install any software. Refer to your

Internet Service Provider’s instructions for installing their software and/or connecting to the Internet.

You can now configure the TCP/IP settings as detailed in Chapter 3, SpeedStream Gateway Setup

USB Installation Method (Microsoft Windows)

Figure 6: USB Connection Installation Diagram