User`s guide

Wireless DSL Gateway User Guide

Chapter 2

Installation

This chapter covers the physical installation of the SpeedStream Wireless DSL Gateway.

Minimum System Requirements

• DSL service and an Internet access account from an Internet Service Provider (ISP).

• Network cables for each device you intend to connect to the Gateway. Use standard CAT5 Ethernet

cables with RJ45 connectors.

• TCP/IP network protocol must be installed on all computers.

• For USB connection to the Gateway, the following operating systems are supported:

− Windows 98

− Windows 2000

− Windows ME and XP

− Mac OS versions 8.6 through 10.2.4

Note: Your configuration may vary slightly from the instructions and illustrations in this chapter.

Refer to your service provider’s documentation, or contact them with questions regarding your

specific configuration.

• For wireless access (Model 6200), you must have a wireless card. If one did not come with your

SpeedStream Gateway, contact your Internet Service Provider for options and availability.

Hardware Installation

You may position the SpeedStream Gateway at any convenient location in your office or home. No

special wiring or cooling requirements are needed; however, you should comply with the safety

guidelines specified in the General Safety Guidelines

on page 7.

Basic Installation Procedure

1. If applicable, install the wireless expansion card.

2. Install line filters if necessary.

3. Connect the cables.

4. Plug the Gateway into the electrical outlet, power on the Gateway, and verify port status.

5. Install USB drivers if necessary.

6. Configure network settings on your computer.

7. Configure the Gateway via the Web-based management interface.

8. Reboot the computer if prompted.

Note Whenever you are required to reboot the Gateway, allow five seconds between turning off the unit

and powering it back on.