Product specifications

Efficient Networks
®
Router family
Command Line Interface Guide
Chapter 6: Remote Commands
Efficient Networks
®
Page 6-3
remote disauthen This command is intended for situations where third-
party routers cannot be authenticated; the target router
will not attempt to authenticate the remote router.
remote disbridge Disables bridging from the target router to the remote
router.
remote enaauthen Initiates the target router authentication negotiation as
defined in the remote router’s database.
remote enable Enables use of an entry in the remote router database.
remote enabridge Enables bridging from the target router to the remote
router.
remote ipfilter Manages the IP filters on the WAN interface.
remote list Lists the remote router entry (or all the entries) in the re-
mote router database.
remote listbridge Lists the current bridge settings for the specified remote
router entry.
remote listiproutes Lists IP information for a remote router or, if the router
name is omitted, for all routers in the remote router da-
tabase.
remote listipxroutes Lists all network IPX route addresses defined for the
LAN connected beyond the remote router.
remote listipxsaps Lists all services defined for the LAN connected beyond
the remote router.
remote listphones Lists the PVC numbers available for connecting to the
remote router.
remote restart Stops the current active session and starts a new active
session for a remote.
remote setatmnsap RFC1577 (Classical IP over ATM) specifies a mecha-
nism to map an ATM Name (called an SNAP) to a PVC.
remote setauthen Sets the authentication protocol used communicate with
the remote router.
remote setbod Sets the bandwidth on demand (BOD) management op-
tion for a DOD (dial on demand) connection, that is, a
connection where the link goes up and down.
remote setbroptions Sets controls on bridging for the remote router entry.
remote setbwthresh Sets the bandwidth threshold for a DOD (dial on de-
mand) connection, that is, a connection where the link
goes up and down.
Table 6-1: Remote Command Listing (Cont.)
Command Function