User guide

Chapter 3. Configuring Router Software 51
Configuring RFC 1483 / RFC 1490 with IPX Routing
This table outlines configuration commands for the RFC 1483 and RFC 1490 Link Protocols with the IPX
Routing Network Protocol.
Note: Appendix B provides step-by-step information on how to configure IPX routing.
RFC 1483 / RFC 1490 with IPX Routing
Steps Settings Commands
System Settings
System Message Optional eth ip addr <ipaddr> <ipnetmask> [<port#>]
Ethernet IP Address As required
dhcp set valueoption domainname <domainname>
dhcp set valueoption domainnameserver < ipaddr >
DHCP Settings Already enabled;
additional settings may be
required
eth ipx addr <ipxnet> [<port#>]
Ethernet IPX Network #
Enter: IPX Network # Frame
Type (default is 802.2)
eth ipx frame <type>
Change Login Optional system admin <password>
Remote Routers
New Entry Enter: Remote Name remote add <remoteName>
Link Protocol/PVC
(for ATM routers)
Select: RFC 1483
Enter: VPI/VCI Numbers
remote setProtocol RFC1483 <remoteName>
remote setPVC <vpi number>* <vci number>
<remoteName>
Link Protocol/DLCI
a
(for Frame Relay routers)
a Enter this information if you are using RFC 1490 in a Frame Relay environment.
Select: FR
Enter: DLCI number
remote setProtocol FR <remoteName>
remote setDLCI < number> <remoteName>
Bridging on/off Must be off remote disBridge <remoteName>
IPX Routes
Add
Enter appropriate info remote addIpxroute <ipxNet> <metric> <ticks>
<remoteName>
IPX SAPs
Add
Enter appropriate info remote addIpxsap <servicename> <ipxNet>
< ipxNode> <socket> <type> <hops> <remoteName>
WAN Network Number Enter appropriate info remote setIpxaddr <ipxNet> <remoteName>
IP and IPX Routing
TCP/IP Routing
(Internet Firewall)
Must be disabled
(optional)
eth ip disable
eth Þrewall <on | off >
IPX Routing Must be enabled eth ipx enable
Store
Reboot
save
reboot