User guide

Chapter 3. Configuring Router Software 49
Configuring PPP over Ethernet (PPPoE)
This table outlines configuration commands for the PPP Link Protocol with the Bridging Network Protocol over
Ethernet.
PPP over Ethernet
Steps Settings Commands
System Settings
System Name Required system name <name>
System Message Optional system msg <message>
Authentication
Password
Required system passwd <password>
DHCP Settings Already enabled; additional
settings may be required
dhcp set valueoption domainname <domainname>
dhcp set valueoption domainnameserver < ipaddr >
Change Login Optional system admin <password>
Remote Routers
New Entry Enter: Remote Name remote add <remoteName>
Set PPPoE Service Enter service name or * for
any service
remote setpppoeservice <service> <remoteName>
Link Protocol/PVC
a
(for ATM routers)
a Enter this information if you are using PPP in an ATM environment.
Select: PPP
Enter: VPI/VCI
remote setProtocol PPP <remoteName>
remote setPVC <vpi number>*<vci number> <remoteName>
Link Protocol/DLCI
b
(for Frame Relay routers)
b Enter this information if you are using PPP in a Frame-Relay environment.
Select: PPP
Enter: DLCI number
remote setProtocol PPP <remoteName>
remote setDLCI <number> <remoteName>
Security Enter system name and
password; disable
authentication
remote setOurSysName <name> <remoteName>
remote setOurPasswd <password> <remoteName>
remote disauthen <remoteName>
Bridging On/Off Must be ON remote enaBridge <remoteName>
IP and IPX Routing
IP Routing If desired, enable and then
deÞne routes and Þlters.
eth ip enable
remote addiproute . . . <remoteName>
remote bindIPVirtualRoute . . . <remoteName>
remote setiptranslate on <remoteName>
IPX Routing If desired, set address remote setipxaddr . . . <remoteName>
Bridging through PPPoE Remote
Remote Bridge remote enabridge <remoteName>
remote addbridge * <remoteName>
Store
Reboot
save
reboot