User guide

48 Chapter 3. Configuring Router Software
Configuring PPP with Bridging
This table outlines configuration commands for the PPP Link Protocol with the Bridging Network Protocol.
PPP with Bridging
Steps Settings Commands
System Settings
System Name Required system name <name>
System Message Optional system msg <message>
Authorization Password Required system passwd <password>
DHCP Settings Already enabled; additional
settings may be required
dhcp set valueoption domainname <domainname>
dhcp set valueoption domainnameserver < ipaddr >
Change Login Optional system admin <password>
Remote Routers
New Entry Enter: Remote Name remote add <remoteName>
Link Protocol/PVC
a
(for ATM routers)
a Enter this information if you are using PPP in an ATM environment.
Select: PPP
Enter: VPI/VCI
remote setProtocol PPP <remoteName>
remote setPVC <vpi number>*<vci number> <remoteName>
Link Protocol/DLCI
b
(for Frame Relay routers)
b Enter this information if you are using PPP in a Frame-Relay environment.
Select: PPP
Enter: DLCI number
remote setProtocol PPP <remoteName>
remote setDLCI <number> <remoteName>
Security
c
RemoteÕs Password
c If the ISP does not support the authentication of the ISP system by the caller, use the command remote disauthen
<remoteName> to disable the authentication.
Choose security level
Enter: Password
remote setAuthen <protocol> <remoteName>
remote setOurPasswd <password> <remoteName>
Bridging On/Off Must be ON remote enaBridge <remoteName>
IP and IPX Routing
IP Routing Must be disabled eth ip disable
IPX Routing Must be disabled eth ipx disable
Store
Reboot
save
reboot