User guide

Chapter 3. Configuring Router Software 47
Configuring PPP with IPX Routing
This table outlines configuration commands for the PPP Link Protocol with the IPX Routing Network Protocol.
Note: Appendix B provides step-by-step information on how to configure IPX routing.
PPP with IPX Routing
Steps Settings Commands
System Settings
System Name Required system name <name>
System Message Optional system msg <message>
Authentication Password Required system passwd <password>
Ethernet IP Address As required eth ip addr <ipaddr> <ipnetmask>[<port#>]
Settings DHCP Already enabled; addit.
settings may be required
dhcp set valueoption domainname <domainname>
dhcp set valueoption domainnameserver < ipaddr >
Change Login Optional system admin <password>
Ethernet IPX Network # Enter: IPX network #
Frame Type (default: 802.2)
eth ipx addr <ipxnet> [<port#>]
eth ipx frame <type>
Remote Routers
New Entry Enter: Remote Name remote add <remoteName>
Link Protocol/PVC
a
(for ATM routers)
a Enter this information if you are using PPP in an ATM environment.
Select: PPP
Enter: VPI/VCI numbers
remote setProtocol PPP <remoteName>
remote setPVC <vpi number>*<vci number>
<remoteName>
Link Protocol/DLCI
b
(for Frame Relay routers)
b Enter this information if you are using PPP in a Fram- Relay environment.
Select: PPP
Enter: DLCI number
remote setProtocol PPP <remoteName>
remote setDLCI <number> <remoteName>
Security
c
RemoteÕs Password
c If the ISP does not support the authentication of the ISP system by the caller, use the command:
remote disauthen <remoteName> to disable the authentication.
Choose security level
Enter: password
remote setAuthen <protocol> <remoteName>
remote setPasswd <password> <remoteName>
Bridging On/Off Must be off remote disBridge <remoteName>
IPX Routes
Add
Enter appropriate info remote addIpxroute <ipxNet> <metric> <ticks>
<remoteName>
IPX SAPs
Add
Enter appropriate info remote addIpxsap <servicename> <ipxNet>
<ipxNode> <socket> <type> <hops> <remoteName>
WAN Network # Enter appropriate info remote setIpxaddr <ipxNet> <remoteName>
IP and IPX Routing
TCP/IP Routing Must be disabled eth ip disable
IPX Routing Must be enabled eth ipx enable
Store
Reboot
save
reboot