User guide

ManualsBrandsEfficient Networks ManualsComputer equipmentRouter family Command line interface

311

312

313

314

315

316

317

318

319

320

Appendix B. Configuring IPX Routing 311

Step 2: Review your Settings

Commands used to review your IPX configuration:

Ð eth list

Ð remote list

Ð ipxsaps

> remote list

INFORMATION FOR <ipx_server >

Status............................... enabled

Protocol in use.................É... PPP

Authentication....................... enabled

Authentication level required........ PAP

IP address translation............... on

Compression Negotiation.............. off

Source IP address/subnet mask........ 0.0.0.0/0.0.0.0

Remote IP address/subnet mask........ 0.0.0.0/0.0.0.0

Send IP RIP to this dest............. no

Receive IP RIP from this dest........ no

Send IP default route if known....... no

Receive IP default route using RIP... no

Keep this IP destination private..... yes

Total IP remote routes............... 0

IPX network number................... 00000456

Total IPX remote routes.............. 1

00002002/1/4

Total IPX SAPs....................... 1

SERVER2 00002002 00:00:00:00:00:01 0451 0004 1

Bridging enabled..................... no

Exchange spanning tree with dest... no

Mac addresses bridged.............. none

> ipxsaps

Service Name Type Node number Network Skt Hops

SERVER2 4 000000000001:00002002:0451 1

> eth list

ETHERNET INFORMATION FOR <ETHERNET/0>

Hardware MAC address................. 00:20:6F:02:4C:35

Bridging enabled..................... no

IP Routing enabled................... no

Firewall filter enabled ........... yes

Process IP RIP packets received.... yes

Send IP RIP to the LAN............. yes

Advertise me as the default router. Yes

Receive default route using RIP.... yes

IP address/subnet mask............... 192.84.210.123/255.255.255.0

IP static default gateway............ none

IPX Routing enabled.................. yes

External network number............ 00000123

Frame type......................... 802.2

Commands used to set and modify your IPX

settings:

eth ipx enable

eth ipx addr <ipxnet> [port#]

Ex: eth ipx addr 123

eth ipx frame [802.2 | 802.3 | DIX]

Ex: remote setipxaddr 456 ipx_server

remote addipxroute <ipxnet> <ticks> <remoteName>

remote addipxsap <servername> <Internal IPX net #>

Ex: remote addipxsap SERVER2 2002 0:00:00:00:00:01

451 4 2 ipx_server

Ex: eth ipx frame 802.2

remote add <remoteName>

Ex: remote add ipx_server

remote setipxaddr <ipxnet> <remoteName> [port#]

Ex: remote addipxroute 2002 1 4 ipx_server