User guide

Appendix A. Network Information Worksheets 299
Appendix A. Network Information Worksheets
To configure the target (local) router, you need to fill out one of the following blank worksheet(s) that applies to
your Link Protocol/Network Protocol situation:
¥ PPP with IP routing configuration
¥ PPP with IPX routing configuration
¥ PPP with bridging configuration
¥ RFC 1483/RFC 1490 with IP routing configuration
¥ RFC 1483/RFC 1490 with IPX routing configuration
¥ RFC 1483/RFC 1490 with bridging configuration
¥ RFC 1483MER/ RFC 1490MER with IP routing configuration
¥ FRF8 with IP routing configuration
A blank worksheet is also available to enter information needed to configure a Dual-Ethernet router with IP
routing enabled.
If you are connecting to more than one remote router:
You need to fill out one set of information for each remote router in the Remote Routers section of the worksheet.
If you are setting up both ends of the network:
You will need a mirror image of the information listed in your target router worksheet in order to configure the
router on the other end of the WAN link.
Note: You may want to review the Chapter 4. Sample Configuration on page 100.