User guide

Chapter 7. Troubleshooting 291
Duplicate IPX SAP <SAP number> to <router/user>
Explanation: There exist two IPX SAPs for the same IPX destination. Remove one of the SAPs.
Duplicate route <IP route> found on remote <router/user>
Explanation: There exist two IP routes to the same IP destination. One route needs to be removed.
Idle
Explanation: Data is not being transmitted.
IP is configured for numbered mode with <router/user>, but no address for it
Explanation: On one end of the connection, remote entries have been configured for numbered mode. On the other
end, remote entries have been configured for unnumbered mode. Neither end cab communicate with the other.
No Signal Detected -- Check WAN Cable!
Explanation: (SDSL-specific error message) Your SDSL router cannot establish connectivity. Check your
physical line.
No system name known - using defaults
Explanation: The router does not have a system name. For PAP/CHAP negotiation, the router will use a default
name and password.
Note: IPX is misconfigured for <router/user> - no IPX WAN network
Explanation: IPX WAN address is wrong or missing.
Note: There is no IPX route statically defined for <router/user>
Informational message.
PPP: Peer not negotiating <IP | BNCP | IPX | CCP> right now
Explanation: One end of the network is not negotiating the same protocol as the other end.
Remote <router/user> didn't accept our CHAP password
Informational message.
Remote <router/user> does not respond to LPC echo. Link closed
The connection was terminated.
Remote <router/user> on <channel> didn't authenticate in time
Explanation: PPP authentication protocol did not succeed.
Remote <router/user> refuses to authenticate
Informational message.
Remote <router/user> tried to use PAP when CHAP was expected
Explanation: The remote end negotiated PAP while its minimum security level in the remote database was set to
CHAP.
Remote <router/user> used wrong password <CHAP | PAP>
Explanation: The remote end has used an invalid password during CHAP or PAP security authentication.
Remote didn't accept our CHAP password
Explanation: The router attempted CHAP security authentication but the remote end rejected the password.
Remote on <interface> didn't authenticate in time
Informational message.
Remote on <interface> rejected our password with PAP
Informational message.