User guide

226 Chapter 5. Command Line Interface Reference
Remote Out-of-frame.... 16
Remote HEC errors...... 0
EOC disabled
Note: For an SDSL statistics example with the EOC enabled, see the sdsl eoc command, page 223.
SDSL TERMINAL
Displays and/or changes the routerÕs status as CO or CPE.
The router is, by default, configured as Customer Premises Equipment (CPE). Use this command if you intend to
configure the router as Central Office equipment (CO).
To determine the current CO/CPE setting, enter sdsl terminal.
cpe Defines the router as the customer premises (CPE) equipment.
co Defines the router as the central office (CO) equipment.
Example:
# sdsl terminal
Customer Premises
Dynamic Host Configuration Protocol Commands (DHCP)The following DHCP commands allow you to:Enable and disable subnetworks and client leases.
sdsl terminal [cpe | co]