User guide

Chapter 5. Command Line Interface Reference 213
Dual-Ethernet Router Commands (ETH)
The following Ethernet commands are used to manage the Ethernet interfaces for the Dual-Ethernet (Ethernet-to-
Ethernet) router and thus are specific to this type of router only.
Note: For non-specific Ethernet commands, refer to Target Router Ethernet LAN Bridging and Routing (ETH), on
page 167.
General information
This Dual-Ethernet router may be configured via the Web Browser GUI or from the Command Line Interface
(CLI). You will need to use the CLI to set up any DHCP options as well as to configure optional features like
IP filtering.
The Dual-Ethernet router has two interfaces:
ETH/0 = Hub with four 10Base-T connectors
ETH/1 = Single 10Base-T connector
Note 1: For configuration information, refer to the Customer Release Notes provided with the Dual-Ethernet
router.
Note 2: If you use the Boot from Network option from the boot menu to perform a boot code update, the
boot request is sent from the ETH/0 interface only.
ETH BR ENABLE
Enables bridging in a Dual-Ethernet environment. This command requires rebooting the router for the change to
take effect.
ETH BR DISABLE
Disables bridging in a Dual-Ethernet environment.
Note: This command requires rebooting the router for the change to take effect.
eth br enable
Example:
eth br enable
eth br disable
Example:
eth br disable