User guide

202 Chapter 5. Command Line Interface Reference
REMOTE SETIPSLAVEPPP
If SetIPSlaveModePPP is yes, the router will accept the IP address that the remote end informs the router that it
has without reguard to how the router was previously configured. If setIPSlaveModePPP is no the router will try
to use the address that it was configured for.
Normally there is no need to change the default (no) value of this option, however, in certain situations where the
router is managed by another party, (as part of a managed service), it might make sense to set this value to yes to
ensure that the central management site always specifies the IP address of the router.
REMOTE SETIPTRANSLATE
This command is used to control Network Address Translation on a per remote router basis. It allows several PCs
to share a single IP address to the Internet. The remote router must assign the source WAN IP address to the
routersÕ local WAN port. This command requires that you define a Source WAN IP Address with the command:
remote setSrcIpAddr
REMOTE SETIPXADDR
Sets the IPX network number for the remote WAN connection.
REMOTE SETL2TPCLIENT
This command is speciÞc to L2TP tunnel conÞguration. Please, refer to the L2TP commands section, L2TP Ñ
Virtual Dial-Up ConÞguration (L2TP), on page 238, for more usage information.
REMOTE SETLNS
This command is speciÞc to L2TP tunnel conÞguration. Refer to the L2TP commands section (page 106) for
usage information.
remote setIPSlavePPP yes|no <remoteName>
remote setIPTranslate on|off <remoteName>
remoteName Name of the remote router (character string).
Example:
remote setIPTranslate on HQ
remote setIpxaddr <ipxNet> [port#]
ixpNet IPX network number represented by 8 hexadecimal characters.
port# Port number of the Ethernet LAN. This number must be either 0 or it may be omitted.
Example:
remote setIpxaddr 789 HQ
remote setl2tpclient <TunnelName><remoteName>