User guide

Chapter 5. Command Line Interface Reference 199
REMOTE SETBROPTIONS
Sets controls on the bridging process.
Warning: Do not change this setting without approval from your system administrator.
REMOTE SETCOMPRESSION
Enables or disables compression between the local router and the remote router.
REMOTE SETDLCI
Refer to the section ISDN Digital Subscriber Line (IDSL), on page 220 for further information regarding this
command.
remote setAuthen <protocol> <remoteName>
protocol chap, pap, or none. The default is pap.
remoteName Name of the remote router (character string).
Example: remote setAuthen pap HQ
remote setBrOptions <option> on|off <remoteName>
option stp
Use the spanning tree protocol for bridging. Set this option on only if the bridging peers support
the spanning tree protocol and you wish to detect bridging loops. The default is on.
Note: This adds a 40-second delay each time the ADSL or ATM link comes up; use only if
necessary.
remoteName Name of the remote router (character string).
Example:
remote setBrOptions stp on HQ
remote setCompression on|off <remoteName>
on Compression will be negotiated between the local and the remote router if both routers are set to
perform compression and if they both share a common compression protocol.
off Disables compression. The default is off.
remoteName Name of the remote router (character string).
Example:
remote setCompression on HQ